WE ARE NOT A PERMIT SERVICE NOR DO WE ARRANGE PERMITS FOR CARRIERS. THIS IS STRICTLY JUST FOR INFORMATIONAL PURPOSES. WE DO NOT ENSURE THE ACCURACY OF THE BELOW INFORMATION SO BE SURE TO READ YOUR PERMIT SHEETS CAREFULLY!
PERMITS: New Mexico oversize permits are valid for five days. New Mexico permits can also be purchased at Ports of Entry provided the size of the load does not require a bridge check or route survey.
OPERATING TIME: 1/2 hour before sunrise to 1/2 hour after sunset, Monday through Saturday. If overweight only, continuous travel is allowed. Continuous travel is allowed if not exceeding 10′ wide, 14′-6″ high, 120′ long and/or 140,000 lbs.
RESTRICTED TRAVEL: Movement prohibited between the hours of 7:00 a.m. – 9:00 a.m. and 4:00 p.m. to 6:00 p.m. in the municipalities of Albuquerque, Santa Fe and Espanola. In Santa Fe, movement is also prohibited between the hours of 11:30 a.m. to 1:30 p.m., except for SR599. Curfew times do not apply to I-25 through Santa Fe, but they do apply on Interstates in Albuquerque. No movement is allowed when any weather condition restricts visibility to less than 1000′, or when wind speed is 25 miles per hour or more. No travel on major holidays. Closure may start at noon on the day before Holiday.
57′-6″ trailer on designated highways
65′ overall length on all other roads
Overhang: 7′ rear
Weight: 80,000 Gross
Single – 21,600
Tandem – 34,320 10′ Spread – 39,000
Tridem – Depends on spacings
ROUTINE PERMIT LIMITS
Length: Depends on routes.
Width: Depends on routes.
Height: Depends on routes. 15′-6″ needs a route survey; 18′ needs utility surveys and clearance from municipal and local authorities.
5 axles – 105,000
6 axles – 119,000
7 axles – 127,000
Single – 23,000 on Interstate, 18,000 – 20,000 all other roads, depending on spacings
Tandem – 46,000
Tridem – 60,000
Quad – 68,000
Note: NM treats a 10+’ spread combination as a tandem rather than two singles.
Over 90′ – one escort
Over 110′ – two escorts
Over 14′ – 1 escort (a few routes require an escort for over 12′ wide)
Over 20′ – also needs police escort and flagman
Height: Over 16′ – one escort and route survey (some routes may require route survey for lower heights)
MISCELLANEOUS: Bulldozer blades and arms over 14′ wide (measured at right angles to the trailer axis) shall be detached and hauled in a manner to not create a safety hazard. Dozer blades shorter than 14′ wide may be hauled without being detached provided the dozer is firmly supported. If buckets, blades, counterweights, etc., are easy to remove, they must be removed, but can be hauled with the load. Blade can be detached and hauled with the dozer on same trailer if the load would be overweight with or without the blade. It should be stated on the permit. On wide loads, side mirrors must extend far enough to avoid view being blocked by the load.
SIGNS, FLAGS & LIGHTS: “Oversize Load” or “Wide Load” signs required on front of towing unit and on rear of load for any oversize, overweight or overweight only load. Red flags at least 12″ square must be affixed to front right and left sides of towing unit and to each corner of the load. Towing vehicles pulling oversize loads that exceed 12′ wide may display an amber rotating flashing beacon atop the cab.
Titan provides solutions customized to meet your needs
Understanding your requirements and objectives is important to us. We listen and work together to create a truly successful supply chain.